Set the DISPLAY switch to TC. Set the TCG switch to SET.

Setting the Time Data

Setting the Time Code

When using both the user bit and the time code, set the user bit first. If the time code is set first, the time code generator will stop while the user bit is being set, causing the set time code to become inaccurate. The time code can be set within the range of 00:00:00:00 to 23:59:59:29.

1

2,5

4

1

2

3 Set TC MODE to “DF” or “NDF” on the “VTR FUNCTION” SUB menu page of MAIN menu 2 of

4.Select DF when the time code is to be advanced during drop frame mode, and NDF when the time code is to be advanced during non-drop frame mode.

4 Set the time code using the SHIFT/ITEM, UP and DOWN buttons.

SHIFT/ITEM button: This is used to cause the digit which is to be set to flash. Each time it is pressed, the flashing digit moves to the right.

UP button:This increments by 1 the figure of the flashing digit.

DOWN button: This decrements by 1 the figure of the flashing digit.

5 Set the TCG switch.

Set the switch to F-RUN when the time code is to be advanced regardless of the VTR’s operation.

Set the switch to R-RUN when the time code is to be advanced only while recording is in progress.

Time code status during battery replacement

The back-up mechanism functions even while replacing the battery to allow the time code generator to continue operating for extended periods of time (approx. 1 year).

Note{

The time code backup accuracy is approx. o/p2 frames when the POWER switch is set to ON, OFF and back ON.

– 83 –