Chapter 4 Adjustments and settings for recording (continued)

If one of the following messages appears when the JOG dial button is pressed, the card will not be formatted

Error message

Remedial action

 

 

CONFIG NG NO CARD

Insert the card.

(setup card has not been inserted)

 

 

 

CONFIG NG ERROR

The card may be defective.

(the card cannot be formatted)

Replace it.

 

 

CONFIG NG

Remove the card to cancel write

WRITE PROTECT

protect.

 

 

5 Press the MENU button to exit the menu operations. The setting menu is cleared, and the displays showing the unit’s current statuses appear at the top and bottom of the viewfinder screen.

<Note>

Data titles cannot be recognized when the setup card was inserted while the CARD READ/WRITE screen was open. Move the arrow (cursor) to the TITLE READ item, and press the JOG dial button.

The data title is recognized, and the title is displayed.

Saving the data settings on the card

1 Perform the menu operations, and display the “CARD READ/WRITE” screen.

Selecting the file No.

2 Turn the JOG dial button to move the arrow (cursor) to the W.SELECT item and press the JOG dial button.

< CARD READ/WRITE >

R.SELECT

:1

READ

 

# W.SELECT

:1

WRITE

CARD CONFIG

TITLE READ

TITLE:

1:******** 5: ********

2:******** 6: ********

3:******** 7: ********

4:******** 8: ********

3 Turn the JOG dial button to select a number from 1 to 8, and press the JOG dial button.

Giving a title to the selected file

4 Turn the JOG dial button to move the arrow (cursor) to the “TITLE : ” item.

< CARD READ/WRITE >

R.SELECT :1

READ

W.SELECT :1

WRITE

CARD CONFIG

TITLE READ

#TITLE:

1:******** 5: ********

2:******** 6: ********

3:******** 7: ********

4:******** 8: ********

5 When the JOG dial button is pressed, the arrow (cursor) moves to the title input area, and the input mode is established.

< CARD READ/WRITE >

R.SELECT :1

READ

W.SELECT :1

WRITE

CARD CONFIG

TITLE READ

;

TITLE:

1:******** 5: ********

2:******** 6: ********

3:******** 7: ********

4:******** 8: ********

6 Press the JOG dial button again and turn it until the character to be set is displayed.

When the button is turned, the character displayed is switched in the following sequence:

Space: ∑

7

letters: A—Z 7

numbers: 0—9 7

symbols: ’, >, <, /, –

7 Press the JOG dial button to enter the character.

8 Turn the JOG dial button to move the arrow (cursor) to the next position (right), and repeat steps 6 and 7 to set the characters (maximum of 8).

66