![](/images/new-backgrounds/1141028/141028139x1.webp)
Adjusting the White Balance/Black Balance
Adjusting the White Balance
Adjusting the white balance and black balance in the order of AWB (white balance adjustment)>ABB (black balance adjustment)>AWB will provide a better picture.
The black balance does not normally need to be readjusted even when the power is turned off and then turned back on.
However, the white balance must be readjusted when the lighting conditions change.
If black balance and white balance adjustments are started when the display mode is set to “2” or “3”, messages informing of the adjustment course and results will appear on the viewfinder screen. Set the display mode to “1” to not display these messages.
ÁSee “Display Mode and Setting Change Message” (page 61) for a description of setting the display mode.
Notes{
ÁThe white balance and black balance cannot be adjusted while the setting menu appears on the viewfinder screen. Therefore, be sure to set the MENU SET/OFF switch to OFF.
ÁThe auto black balance (ABB) must be readjusted without fail when the MASTER GAIN value has been changed on the “LOW SETTING”, “MID SETTING” or “HIGH SETTING” SUB menu pages of MAIN menu screen 1 of 4, when the super gain setting has been changed using the SUPER GAIN button, and when the GAMMA setting (ON/OFF) on the “CAMERA SETTING” SUB menu page of MAIN menu screen 1 or 4 has been switched.
ÁWith artificial lights, particularly with fluorescent lights and
These phenomena can be reduced by setting the shutter speed to 1/100. For this reason, wher- ever the unit is used under fluorescent or
1 Set the switches as shown in the figure.
FILTER knob
MENU SET/OFF: OFF
WHITE BAL: A or B
OUTPUT: CAM
GAIN: Normally, set to 0 dB. When it is too dark, it is set to the appropriate gain.
When the positions of the GAIN and WHITE BAL switches are changed, a message informing the operator of the new settings will appear on the setting change message display area of the viewfinder screen. (However, this display appears only when the display mode is set to “3”.)
2 Select the FILTER knob setting in accordance with the lighting conditions.
ÁRefer to the description of the ¬ FILTER knob (page 15) in the Shooting and Recording/ Playback Function Section for examples of the FILTER knob settings. If the FILTER knob setting is changed, a message informing the operator of the new setting will appear on the setting change message display area of the viewfinder screen. (However, this display ap- pears only when the display mode is set to “3”.)
– 70 –