Operating Instructions
Configure commands to execute for detection
You can specify executing commands for motion detection and/or alarm detection. Specify the commands in their respective pages when you execute the commands specified (see page 29, 32, 61).
Detection Commands Page
Setting | Description |
|
|
Commands for | Set a command (Short to GND or Open) to execute at the |
Camera External | external equipment that is connected to the camera for |
Output Settings | motion detection and/or alarm detection and an unlock time |
| for the specified command (see page 34). |
|
|
Optional Command | Select optional commands to execute when motion or an |
| alarm is detected. Default is Beep 1000 1000*. |
|
|
Controlling Command | You can select Execute a command only once at the start of |
Execution | recording, or you can specify a number of seconds during |
| which commands will not being executed after a command |
| has finished executing (see page 35). |
|
|
*The Beep program is installed with this software.
"Beep 1000 1000" is a command that makes a beeping sound at 1000 Hz for 1000 ms. You can set user created commands as well.
However, depending on the command's operation, recording performance may be affected. Use optional commands after thorough testing. Recorded image quality cannot be guaranteed when using optional commands.
33
