9.1.4.Removing the DIMM Memory Card
<N1> | <N1> | DIMM Cover |
|
Hook
Hook
DIMM Memory Card
1.Remove the two Screws <N1>, and remove the DIMM Cover.
2.Open the right and left Hooks of the DIMM Memory Card outward, and remove the DIMM Memory Card.
Screws <N1>: XSB2+3FNL
9.1.5.Removing the Keyboard
Hooks
1.Release the seven Hooks fixing the rear side of the Cen- ter Cover.
Hooks | Center Cover |
Hooks
<N9>
KBD Angle L
<N9>
Keyboard
KBD Angle R
2.Lift the upper part of the Center Cover and draw it back- ward, release the six Hooks fixing the front side of the Center Cover, and then remove the Center Cover.
3.Remove the four Screws <N9> and the KBD Angle L and R.
4.Lift the upper part of the Keyboard and draw it backward, and then turn the Keyboard over forward.
KBD WP Sheet
Connectors
Keyboard | Connector |
| (CN25) |
KBD FPC
5.Remove the KBD WP Sheet.
6.Disconnect the two KBD Cables from the two Connectors (KBD FPC).
7.Remove the Keyboard.
8.Disconnect the Cable from the Connector (CN25).
9.Remove the KBD FPC,
Screws <N9>: DFHE5025XA
9.1.6. Removing the Speaker and the LED PCB
| Sheet | |
CN1002 | <N9> | |
| ||
Tape | CN1003 | |
LED PCB | ||
Speaker | ||
| ||
Holder | Tape | |
Speaker L |
| |
| Speaker | |
| Holder | |
| Speaker R |
1.Remove the two Speaker Holders.
2.Remove the two tapes, and disconnect the two Speaker Cables from the two Connectors (CN1002, CN1003)
3.Remove the Speaker L and R.
4.Remove the Sheet.
5.Remove the two Screws <N9>, and Remove the LED PCB.
