9.2.10. Setting the PC Card Ejector and Lithium Battery
1.Attach the Lithium Battery to the Main PCB.
2.Pass the Lead Wire of the Lithium Battery through the groove of the Main PCB, and connect it to the Connector (CN14) on the back side.
3.Fix the PC Card Ejector to the Main PCB using the two Screws<N9>.
Screws <N9>: DFHE5025XA
Lithium Battery
(to CN14)
CN14
PC Card Ejector
Main PCB
<N9>
Arranging the Lithium Battery
Safety Working S2
Pass the Cable through the groove of the Main PCB.
Match the end of the Tape. (0 to 1 mm)
Tape
Main PCB
Connect to the Connector (CN14) on the back side.
Match the end of the Tape. (0 to 1 mm)
Fix the Cable using the Tape.
Pass the Cable between the parts. (Avoid running over the parts.)
Lithium Battery
9.2.11.Setting the Main PCB
Note:
After replacing the Main Board, rewrite the BIOS ID.
1.Set the MP Guide to the Main PCB.
2.Set the Main PCB to the computer.
3.Fix the Main PCB using the six Screws<N9>.
4.Connect the ten Cables to the corresponding Connecters (CN6, CN7, CN24, CN19, CN28, CN21, CN802, CN18, CN15, CN25).
Screws <N9>: DFHE5025XA
<N9> | CN21 |
CN6 | CN802 |
| |
| CN18 |
Main PCB | CN15 |
CN7
CN24
CN28<N9>
CN19
MP Guide
CN26
