1.Disconnect the LCD/INV. Cable from the Connector on the Inverter.
2.Remove the LCD Unit.
3.Remove the Inverter with the Inverter Case.
4.Remove the two Screws <N18>, and then the
Screws <N18>: XQN17+BJ6FJ
9.1.19.Removing the Touch PAD and PAD PCB
Palm Rest Sheet
Pad WP Sheet A
<N20>
<N20>
<N20>
<N20>
PAD Base Ass’y
PAD Button
WP Rubber
Touch PAD
PAD SW PCB
CN1302
<N14>
<N14> CN1301 <N14>
Sheet
1.Remove the Palm Rest Sheet.
2.Remove the four Screws <N20>, and then PAD Base Ass'y.
3.Disconnect the two Cables from the two Connectors (CN1301, CN1302).
4.Remove the three Screws <N14>.
5.Remove the PAD Button WP Rubber and PAD SW PCB.
6.Remove the Touch PAD.
Screws <N14>: DRHM0106ZA
Screws <N20>: DXQT2+G4FCL
9.1.20. Removing the Finger PCB
Finger PCB | <N9> |
| <N9> |
<N9>
FP FFC Cable | Finger Sensor Base |
Preparation
Perform the steps up to removing of the Main PCB.
1.Remove the three Screws. <N9>
2.Remove the Finger PCB and Finger Sensor Base.
Screws <N9>: DFHE5025XA
