Preparation
19
VQT1B25
Setting Date/Time (Clock Set)∫Initial setting
The clock is not set so the following screen
appears when you turn the camera on.
A: [MENU/SET] button
B: Cursor buttons
1Press [MENU/SET].
2Press 3/4/2/1 to select the
date and time.
A: Time at the home area
B: Time at the travel destination (P74)
•2/1: S elect the desired item.
•3/4: Set the display order for the date
and time.
• : Cancel without setting the clock.
3Press [MENU/SET] to set.
•Turn the camera off after setting the clock.
Then set the mode dial to a recording
mode to turn the camera on and check
whether or not the clock setting is correct.
∫Changing the clock setting
1Press [MENU/SET].
2
Press
3/4
to select [CLOCK SET]. (P90)
3Press 1 and then perform steps 2 and
3 to set the clock.
4Press [MENU/SET] to close the menu.
•You can also set the clock in the
[SETUP] menu. (P22)
•When a fully charged b attery has been
inserted for more than 24 hours, the clock
setting is stored (in the camera) for at
least 3 months even if the battery is
removed. (If you insert a battery that is not
sufficiently charged, the length of time that
the clock setting is stored may become
less.) However, the clock setting is
canceled after this length of time. In this
case, set the clock again.
•You can set the year from 2000 to 2099.
The 24-hour system is used.
•If the clock is not set, the correct date
cannot be printed when you stamp the
date on the pictures with [DATESTAMP]
(P100) or order a photo studio to print the
pictures. (P103)
OFF ON
PLEASE SET THE CLOCK
CLOCK SET
MENU
M/D/Y
JAN
112007
..
0000
:
CLOCK SET
SELECT SET EXIT
MENU
:
:
CANCEL
DMC-FZ8_PP ENG.book 19 ページ ２００６年１２月２６日 火曜日 午後４時２０分