Panasonic FX-301 manual Sensor-PLCconnection system, SC SERIES Bank selection unit, Applications

FX-301

Optional units for greater freedom and control when installing

Sensor-PLC connection system SC SERIES Bank selection unit

FX-CH SERIES

This wire-saving system enables the collective connection of up to 16 I/O devices with an MIL connector. Scattered installation is also possible with the help of a sensor separate unit.

Without directly manipulating the sensor itself, you can simultaneously switch up to 16 fiber sensors’ settings using an external emitted signal. (Load and save)

mAlso possible with the FX-301series’ databank function

APPLICATIONS

Workpieces detection

This standard type of FX-301using red light has a four-chemical emitting element for stable sensing over long periods.

Sensing film meandering

Infrared LED type is ideal for sensing environments with light restrictions, such as places where light-sensitive film is being handled. (The emission peak wavelength:

940nm 0.037 mil.) It includes full-auto teaching function which allows sensitivity to be set without stopping the workpiece line.

Sensing semi-transparent stickers

The blue LED type greatly reduces the dampening rate, making it ideal for delicate sensing.

Detecting chip component

Because of low light intensity fluctuations when detecting minute moving objects, decrease the hysteresis in PRO mode and accurate sensing will be possible in high- speed mode. This method is optimal for chip component verification in taping equipment.

Sensing register marks

The green LED type can accurately discriminate between red and yellow, that cannot be easily detected using red LED type.

Detecting register marks on a transparent sheet

When detecting registration marks on transparent film with a thru-beam type, the S-D (reduced light intensity) mode will enable minute light intensity fluctuation sensing.

08/2005 71