12
VQT1Z09
Quick Guide∫Charging the battery
1Connect the AC cable to the AC adaptor and
the AC outlet.
2Insert the battery into the AC adaptor by
aligning the arrows.
∫Inserting the battery
Install the battery by inserting it in the direction
shown in the figure.
AInsert the battery until it clicks and locks.
∫Inserting/removing an SD card
1) Open the LCD monitor.
≥Check that the access lamp has gone off.
2) Open the SD card cover by sliding the OPEN
lever B.
3) Insert/remove the SD card.
≥Face the label side C in the direction shown in
the illustration and press it straight in as far as
it will go.
≥Press the center of the SD card and then pull it
straight out.
4) Securely close the SD card cover.
≥Securely close it until it clicks.
∫How to turn on the powe r
Turn on the power by changing the mode to ,
or while pressing the lock release
button A.
≥
To turn off the power, change the mode to
OFF
.
Access lamp [ACCESS] A
≥When this unit is accessing the SD card or
built-in memory, the access lamp lights up.
Charging lamp
[CHARGE] A
Lights up:
Charging
Goes off:
Charging completed
OPEN
≥Rotate the mode dial while at the same
time pressing in the lock release button if
changing from OFF to another mode.
≥Align with B.
≥Status indicator C
HDC-TM300
≥Rotate the mode dial while at the same
time pressing in the lock release button if
changing from OFF to another mode.
≥Align with B.
≥Status indicator C
OFF
HDC-HS300
HDCSD300&HS300P-VQT1Z09_eng.book 12 ページ 2009年1月21日 水曜日 午前9時53分