76
VQT1Z09
Bass setting Change the lower setting of the built-in microphone according
to your choice.
≥Change the mode to .
≥The Intelligent Auto Mode is set to off. (l47)
Select the menu. (l33)
[RECORD SETUP] # [BASS SETTING] # desired setting
[0dB]/[+3dB]/[+6dB]/[LOWCUT]
≥Normally set to [0dB].
≥Select [+3dB] or [+6dB] to get strong power feeling at bass level.
Select [LOWCUT], when recording is done outside in strong wind
or when wind noise cannot be reduced only with the wind noise
reduction function.
Zebra
AZebra pattern
Parts where white saturation (color saturation) is likely to
occur (extremely brightly lit or shiny parts) are displayed with
diagonal lines (zebra pattern).
≥Change the mode to or .
≥The Intelligent Auto Mode is set to off. (l47)
Select the menu. (l33)
[RECORD SETUP] # [ZEBRA] # [ON]
≥It is possible to set from the quick menu in Manual Mode. (l34)
≥You can record an image with little white saturation if you
manually adjust the shutter speed or brightness (iris/gain) (l84).
≥The zebra pattern does not appear on the images actually
recorded.
Luminance
[OFF]:
Not display
[ALWAYS]:
Constantly display
[ON ADJUST]:
Display only when [IRIS] is
adjusted. (l84)
ALuminance display frame
BLuminance level
Displays the luminance level of the center of the screen
(luminance display frame) in %.
It makes the adjustment of the brightness of the object easier,
by checking the luminance level of the object, when recording
same object in different surroundings.
Adjust the brightness using [IRIS]. (l84)
≥Change the mode to or .
≥The Intelligent Auto Mode is set to off. (l47)
Select the menu. (l33)
[RECORD SETUP] # [LUMINANCE] # desired setting
≥It is possible to set from the quick menu in Manual Mode. (l34)
≥This function’s default setting is [ON ADJUST].
≥Luminance level is displayed between [0%] and [99%]. It will be
displayed as [99% ] when it is over 99%.
Function Effect/Setting method
50%
HDCSD300&HS300P-VQT1Z09_eng.book 76 ページ ２００９年１月２１日　水曜日　午前９時５３分