147
VQT1Z09
Problem Check points
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥Turn on the power again. If normal conditions are not
restored yet, remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC adaptor.
Then about 1 minute later, turn on the power again.
(Conducting the above operation while the media is being
accessed may damage the data on the media.)
≥If normal operation is still not restored, detach the power
connected, and contact consumer support. (l165, 166)
Recording does not start
although power is
supplied to this unit and
the SD card is correctly
inserted.
≥A message is displayed and you cannot record when the
HDD does not operate normally due to the temperature of
the unit being too high or low, when the built-in memory
does not operate normally, or when the SD card cover
cannot be closed due to failure of the SD card cover. In this
case, press the recording start/stop button to display the
media change message, allowing you to change the
recording media.
Item other than the
touched one is selected. ≥Calibrate the touch screen. (l42)
The remote control does
not function. ≥Remote control cannot be operated when the [REMOTE
CONTROL] is set to [OFF].
≥The button-type battery of the remote control may have run
out. Replace it with a new button-type battery. (l44)
The remaining time
indication or the elapsed
time indication is not
shown.
≥If you set [SETUP] > [DISPLAY] > [OFF], indications
other than warnings and date etc are not displayed. (l36)
The unit arbitrarily stops
recording. ≥Use an SD card that can be used for motion picture
recording. (l28)
When the unit stops while a usable SD card for recording
motion pictures (l28) is used, the data writing rate has
deteriorated. We recommend formatting the SD card being
used. (l106)
≥If [AGS] is [ON], record in the normal horizontal position or
set [AGS] to [OFF]. (l73)
≥
If the unit is exposed to strong vibrations or shocks while
recording on HDD, recording may stop to protect the HDD.
If the unit is used in a place with loud sounds, the recording
may stop due to sound vibrations. Recording data on an SD
card is recommended in these places.
≥Repeated recording and deletion of motion pictures may
reduce the usable time for recording on a media you use. In
that case, format the media.
HDCSD300&HS300P-VQT1Z09_eng.book 147 ページ ２００９年１月２１日 水曜日 午前９時５３分