Cleaning the Unit

3

4

Clean the scanning section glass and sensor rollers using the accessory roller cleaning paper.

Then remove the dirt on the document sensors and double feed detection sensors with the included blower.

•When cleaning the bottom scanning section glass, do not touch the tip of the plastic pointer (black) in the back of the unit.

If the paper path selector is set to the lower side, it may cause an injury.

•If the sensor roller is removed while cleaning, re-attach it after cleaning. (Refer to page 40 for re-attachment.)

Close the front door. (See the diagram in step 4 on page 38.)

•Push both sides of the front door down slowly until it clicks into place.

Document sensors

Double feed detection sensors

 

Document sensor

Pointer (Black)

Scanning section glass

Sensor rollers

 

 

 

Document sensors

Document sensor

 

Document sensor

Left side view

Paper detection sensor

¥How to clean the document sensor, double feed detection sensor or paper

detection sensor

Remove the brush and blow off the dirt through the document sensor hole, double feed detection sensor hole or paper detection

sensor hole.

Document sensor, double

feed detection sensor

Blower

 

or paper detection sensor

 

39