1. Introduction and Installation
10

1.4.2 Rear view

Removing the shipping tape
Remove the shipping tape (1) and pad (2).
Note:
LShipping tape positions are subject to change
without notice.
Installation

1.5 Toner cartridge and drum unit

The supplied toner cartridge is a starter toner cartridge.
Caution:
LRead the following instructions before you begin
installation. After you have read them, open the
drum unit protection bag. The drum unit contains
a photosensitive drum. Exposing it to light may
damage the drum. Once you have opened the
protection bag:
Do not expose the drum unit to light for more
than 5 minutes.
Do not touch or scratch the black drum
surface.
Do not place the drum unit near dust or dirt,
or in a high humidity area.
Do not expose the drum unit to direct
sunlight.
LWe cannot be responsible for any damage to the
unit or degradation of print quality which may
occur from the use of a non-Panasonic toner
cartridge and drum unit.
LDo not leave the toner cartridge out of the
protection bag for a long time. It will decrease the
toner life.
LDo not add toner to the toner cartridge.
1Before opening the protection bag of the new toner
cartridge, shake it vertically more than 5 times.
2Remove the toner cartridge and drum unit from the
protection bags.
LDo not touch or scratch the black drum surface
(1).
ARecording paper guides
BSpeaker
CUSB interface connector
DLAN interface connector
ELED
FExternal telephone jack
GTelephone line jack
HManual input tray
IPower inlet

A

B C H I

FG

D

E

1
2
1
1
FLB882CX-PFQX2773ZB-OI-en.book Page 10 Friday, October 5, 2007 11:45 AM