5. Copier
35
5.1.2 Using the auto document feeder
1If the {COPY} light is OFF, turn it ON by pressing
{COPY}.
2Set the original (page 19).
3If necessary, change the resolution and contrast
according to the type of document.
LTo select the resolution, see page 34.
LTo select the contrast, see page 34.
4If necessary, enter the number of copies (up to 99).
5{START}
LThe unit will start copying.
6After you finish copying, press {STOP} to reset the
settings you set in step 3 and 4.
Note:
LTo stop copying, see page 71.
5.2 More copying features
LMake sure that the {COPY} light is ON.
5.2.1 To enlarge/reduce a document
1Set the original (page 19).
2Press {ZOOM} repeatedly to select the enlargement
/ reduction rate that fits the size of your document
and recording paper.
–“ZOOM =100%”
–“50%”
–“200%”
–“97%(LTR>A4)”
–“94%(A4>LTR)”
–“83%(LGL>A4)”
–“78%(LGL>LTR)”
LIf you select “ZOOM =100%”, press {V} or {^}
repeatedly to change the enlargement /
reduction rate by 1% at a time from “25%” to
“400%”.
You can also enter the desired percentage
specifically by using the dial keys.
3{SET}
4If necessary, enter the number of copies (up to 99).
i {START}
5After you finish copying, press {STOP} to reset this
feature.
Note:
LEnlargement / reduction copy is not available for
quick ID copy feature (page 36), poster feature (page
37) or N in 1 feature (page 37).
LYou can hold the previous zoom (enlargement /
reduction) setting (feature #468 on page 62).
LWhen using the scanner glass, the unit will only
enlarge the right top corner of the document starting
from the l mark on the unit.
LWhen using the auto document feeder, the unit
will only enlarge the centre of the upper part of the
document. To make an enlarged copy of the bottom
of the document, turn the document around, and
then make a copy.
{COPY}{STOP}
{START}
FLB882CX-PFQX2773ZB-OI-en.book Page 35 Friday, October 5, 2007 11:45 AM