112
Operations
For assistance, call 1-800-435-7329.
Problem Cause & Remedy
Possible causes are as follows.
—Telephone circuit is not good.
—You received a call-waiting signal.
—The other party stopped reception.
—The other party ran out of the recording paper.
Transmit again after confirming with the other party.
The other party did not answer the call or the line was busy.
Transmit again after waiting a while.
The the dialing mode setting (tone or pulse) is not correct.
Open the Setup dialog box and confirm the dialing mode setup
check box in the Line tab.
Set the fax machine to the overseas transmission mode (p. 57).
I see a “Sending a fax failed.”
message.
I see a “No response” message.
I cannot make an international
transmission.
Transmission
Problem Cause & Remedy
Click the button to exit PANA LINK, and restart.
If PANA LINK does not closed, please force it to close by pressing
Ctrl+Alt+Delete keys.
The PANA LINK does not work
properly.
General (cont.)
Problem Cause & Remedy
You probably checked the [Receive directly to Facsimile Unit]
check box to activate in the Reception tab in the Setup dialog box.
If so, click this check box to deactivate.
The setting of the PC LINK on the fax machine is off. Turn it on
(p. 104).
The PANA LINK application does not operate. Start the PANA LINK
application.
Open the Setup dialog box, then check the [Receive directly to
Facsimile Unit] check box to activate in the Reception tab.
Print after selecting the desired printer from the Print dialog box.
Possible causes are as follows.
—The line condition was not good.
—The reception was interfered with the call waiting signal.
Check with the other party and try again.
The fax machine receives a fax, but I
want to receive it with the PC.
The PC receives a fax, but I want to
receive it with the fax machine.
I want to print out the received fax
with another printer.
The “Receiving a fax failed.”
message is displayed.
Reception
Problem Cause & Remedy
The facsimile unit is probably busy. Try again after the other
operation is completed.
There might not be enough free space on the hard disk. Try again
after deleting unnecessary files or closing unused applications.
There might not be enough RAM. Try again after closing some
applications.
Restart the PC, then try again.
I cannot scan.
Scan and copy