Panasonic KX-T61610 manual Code

To lock

	I				-
LIFTHANDSET	DIAL'%"	DIAL	DIAL LOCK	DIAL"#"	HANGUP
ORPRESS		LOCKCODE	CODEAGAIN		ORPRESS
"SP-PHONE"		(OOOthrough			"SP-PHONE"
		999)
To unlock			J
I
LIFTHANDSET	OlAL"6"	DIAL	DIAL "%"	HANGUP
ORPRESS		LOCKCODE		ORPRESS
"SP-PHONE"		(OOOlhrough		"SP-PHONE"
		999)

To conjirtn the lock code (extension ‘1 only)

0 Be sure the handset is in the cradle and the SP-PHONE button is off. eSet the MEMORY switch of the KX-T61630 to “PROGRAM”.

0 You may use the NEXT or PREViOUS bulton

					instead of dialing the Extension Number.
OlAL"8"	OIALTHE EXTENSION			PRESS	After conjirming all the codes, return
	NUMBER(11 through 26)			"END"
					the MEMORY		switch	to “SET”.
	LOCKCODEWILLEE
	DISPLAYED				\
Description					To	unlock
					<-___
Locking an estension prohibits another uset					1. Lift the handser or press the SP-PHONE but-
						ton.
from dialing on an outside line until unlocked.
Even the emergency call can not be dialed.					2.	Dial	(6).
The followings are possible at the locked exten-
					3. Dial the lock code.
sion.
Receiving	an	outside	call		4.	Dial	(#).
Dialing and		receiving	an infercom call			“ID	CODE	RESET” will be displayed.
Call pick	up				5. Hang up or press the SP-PHONE button.
Dialing and receiving a doorphone call

Dialing a door opener, etc.

Operation

.To lock

1.Lift the handset or press the SP-PHONE but- l0t1.

2.Dial (6).

3.Dial the lock code.

Lock code must be 3 digits (000 through 999).

4.Dial Ihe same lock code again.

5.Dial (#).

“ID CODE SET” will be displayed. -

6.Hang up or press rhe SP-PHONE button.

Conditions

l When dialing to an outside line using a locked exfetuion, reorder to;ie will be heard.

l Lock code must be 3 numerical*digits except the “#” and “Jc” buttons.

OIf you use a standard telephone;

To lock, dial (0) instead of (#) at step 5. To unlock, dial (0) instead of (#) at step 4.

a)

Note:

To operate features after setting “Auto CO Hunt- ing”, press the ICM button instead of lifting the handset al step 1. This is because lifting the Iiandset causes the line IO be connected to a CO line.

22 - _