Programmable Settings
Programming via direct commands
You can also program features using “direct
Details of each feature can be found on the corresponding pages.
Important:
LBefore programming, make sure the handset and base unit are not being used. The handset must be operated near the base unit and while off the base unit or charger.
1 Press {MENU} (middle soft key), then press {#}.
Enter direct No.
:
2
3
4
5
Enter the desired feature code (shown below).
Enter the desired setting code (shown below).
LThis step may vary depending on the feature being programmed.
Press {SAVE}.
Press {OFF} to exit programming mode.
Note:
LIf the handset beeps 3 times, you entered an invalid code. Enter the correct code.
LIf you make a mistake or enter the wrong code, press {OFF} then start again by pressing {MENU}.
Direct commands chart
Important:
LThe default settings are indicated by *.
Feature | Feature code | Setting code | Page |
Date and time | {1} {0} {1} | Enter date and time. | 20 |
|
| (Default: 12.31.2005) |
|
Change language | {1} {1} {0} | {1}: English* {2}: Spanish | 53 |
|
|
|
|
Set dial mode | {1} {2} {0} | {1}: Pulse {2}: Tone* | 20 |
|
|
|
|
Set flash time | {1} {2} {1} | {1}: 700 ms* {2}: 600 ms | 53 |
|
| {3}: 400 ms {4}: 300 ms |
|
|
| {5}: 250 ms {6}: 110 ms |
|
|
| {7}: 100 ms {8}: 90 ms |
|
Set line mode | {1} {2} {2} | {1}: A {2}: B* | 54 |
|
|
|
|
HS registration | {1} {3} {0} | Go to step 5 on page 56. | 56 |
|
|
|
|
For assistance, please visit http://www.panasonic.com/consumersupport | 45 |