Useful Information
Problem
The 2nd caller’s information is not displayed during an outside call.
Cause/solution
R In order to use Caller ID, call waiting, or Call Waiting Caller ID (CWID), you must first contact your service provider/ telephone company and subscribe to the desired service. After subscribing, you may need to contact your service provider/telephone company again to activate this specific service, even if you already subscribed to both Caller ID and Call Waiting with Caller ID services (CWID).
Answering system
Problem | Cause/solution | ||
The unit does not record new |
| R The answering system is turned off. Turn it on (page 31). |
|
messages. | R The message memory is full. Erase unwanted messages | ||
|
| (page 32). | |
|
| R The recording time is set to “Greeting only”. Change | |
|
| the setting (page 35). | |
|
| R If you subscribe to a voice mail service, messages are | |
|
| recorded by your service provider/telephone company, not | |
|
| your telephone. Change the unit’s number of rings setting or | |
|
| contact your service provider/telephone company (page 34). | |
|
|
|
|
I cannot operate the answering | R Someone is using the unit. Wait for the other user to finish. | ||
system. | R A caller is leaving a message. Wait for the caller to finish. | ||
|
| R The handset is too far from the base unit. Move closer. | |
|
|
|
|
I cannot operate the answering | R The remote access code is not set. Set the remote access | ||
system remotely. | code (page 33). | ||
|
| R You are entering the wrong remote access code. If you have | |
|
| forgotten your remote access code, enter the remote access | |
|
| code setting to check your current code (page 33). | |
|
| R Press each key firmly. | |
|
| R The answering system is turned off. Turn it on (page 34). | |
|
|
|
|
|
|
| |
Liquid damage |
|
| |
|
| ||
Problem | Cause/solution | ||
Liquid or other form of moisture has |
| R Disconnect the AC adaptor and telephone line cord from the |
|
entered the base unit/handset. | base unit. Remove the batteries from the handset and leave | ||
|
| to dry for at least 3 days. After the base unit/handset are | |
|
| completely dry, reconnect the AC adaptor and telephone | |
|
| line cord. Insert the batteries and charge fully before use. If | |
|
| the unit does not work properly, contact an authorized | |
|
| service center. | |
|
|
|
|
Caution:
R To avoid permanent damage, do not use a microwave oven to speed up the drying process.
44 | For assistance, please visit http://www.panasonic.com/help |
