Error messages
Display message Cause/solution
Base no power
or
No link. Reconnect
AC adaptor.
or
No link.
RThe handset has lost communication with the base unit. Move
closer to the base unit and try again.
RUnplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
RThe handset’s registration may have been cancelled.
Re-register the handset (page 49).
RWhen “No link.” is displayed during a power failure, place
a handset on the base unit to supply power to the base unit.
Check Phone Line RThe supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 9).
Error RRecording was too short. Try again.
Failed RPhonebook copy failed (page 21). Confirm the other handset
(the receiver) is in standby mode and try again.
Incomplete RThe receiver’s phonebook memory is full. Erase the unwanted
phonebook entries from the other handset (the receiver) and
try again.
Memory Full RThe phonebook memory is full. Erase unwanted entries
(page 20).
RMessage memory is full. Erase unwanted messages
(page 35, 36).
RThe call barred list memory is full. Erase unwanted entries
(page 30).
Use rechargeable
battery.
RA wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 5, 7.
You must first
subscribe to Caller
ID.
RYou must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
45
Useful Information
TG68xxBX_UE(en)_0523_ver021.pdf 45 2013/05/23 16:41:17