Changing the base unit PIN
(Personal Identification Number)
Important:
RIf you change the PIN, please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, contact
an authorised service centre.
1M N#132
2Enter the current 4-digit base unit PIN
(default: “0000”).
3Enter the new 4-digit base unit PIN. a
MOKN
4MbN: “Yes” a MOKN a MeN
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 5. Contact your Panasonic dealer for
details.
Important:
RBefore registering the repeater to this base
unit, you must turn the repeater mode on.
RDo not use more than one repeater at a
time.
Setting the repeater mode
1M N#138
2MbN: Select the desired setting. a MOKN
a MeN
Note:
RAfter turning the repeater mode on or off,
may be displayed on the handset
momentarily. This is normal and the
handset can be used once is displayed.
Registering the DECT repeater
(KX-A405) to the base unit
Note:
RPlease use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1Base unit:
Proceed with the operation for your model.
nKX-TG6811 series: page 3
Press and hold MN for about 5
seconds. (No registration tone)
nKX-TG6821 series: page 3
Press and hold MN for about 5
seconds, until the registration tone
sounds.
RThe next step must be completed
within 90 seconds.
2DECT repeater:
Connect the AC adaptor, then wait until
the indicator and indicator light
green.
3Base unit:
To exit the registration mode, press MN.
RThe registration tone stops.
(KX-TG6821 series: page 3)
31
Programming
TG68xxBX_UE(en)_0523_ver021.pdf 31 2013/05/23 16:41:16