Replacing Belt
Motor Shaft | Belt |
Arbre du moteur | Courroie |
Eje del motor | Correa |
| Agitator |
| Agitateur |
| Agitador |
Belt |
|
Courroie |
|
Correa |
|
Motor Shaft 
Arbre du moteur
Eje del motor
Carpet/Bare
Floor Selector
Shaft
Arbre d'entraînement |
| |
du sélecteur |
| |
tapis/plancher | Belt Groove | |
Selector | ||
Rainure de la courroie | ||
| ||
| Polea para correa |
➢Replace belt whenever a burning rubber smell caused by excessive slippage occurs.
➢Place
➢Remove lower plate.
➢Remove agitator by carefully lifting out.
➢Remove worn or broken belt.
➢Loop new belt (Panasonic Type UB8 only) around motor shaft and brush pulley; see illustration for correct belt routing.
Belt |
| |
Courroie |
| |
Correa |
| |
| Agitator | |
End Cap | Agitateur | |
Bouchon | Agitador | |
Tapa del extremo | ||
|
Lower Plate | Tabs |
Plaque inférieure | Languettes |
Base inferior | Lengüetas |
➢Clean agitator and reinstall the two
(2) end caps.
➢Reinstall agitator back into nozzle housing grooves.
➢After reinstalling the agitator, turn it by hand to make sure that belt is not twisted or pinched and that all rotating parts turn freely.
➢Reinstall lower plate. Ensure tabs are locked into slots.
- 50 -
