Precautions with regard to safety
Do not use the projector in a bath or shower. Fire or electric shocks can result.
Do not place your skin into the light beam while the projector is being used.
Strong light is emitted from the projector’s lens. If you place directly into this light, it can hurt or damage your skin.
Do not look into the lens while the projector is being used.
Strong light is emitted from the projector’s lens. If you look directly into this light, it can hurt and damage your eyes.
Be especially careful not to let young children look into the lens. In addition, turn off the power and disconnect the mains plug when you are away from the projector.
Do not place your hands or other objects close to the air outlet port.
Heated air comes out of the air outlet port. Do not place your hands or face, or objects which cannot withstand heat close to this port [allow at least
15 cm (6") of space], otherwise burns or damage could result.
Replacement of the lamp is recommended to be carried out by a qualified technician.
The lamp has high internal pressure. If improperly handled, explosion might result.
The lamp can easily become damaged if struck against hard objects or dropped, and injury or malfunctions may result.
When replacing the lamp, allow it to cool for at least one hour before handling it.
The lamp cover gets very hot, and touching it can cause burns.
Before replacing the lamp, be sure to disconnect the mains plug from the mains socket.
Electric shocks or explosions can result if this is not done.
Do not allow infants or pets to touch the remote control unit.
Keep the remote control unit out of the reach of infants and pets after using it.
Do not set up the projector outdoor.
The projector is designed for indoor use only.
Dispose of unneeded power cords, cap and packaging materials appropriately after removing the product.
Important Information
CAUTIONS
Do not cover the air inlet port or the air outlet port. Doing so may cause the projector to overheat, which can cause fire or damage to the projector.
Do not place the projector in narrow, badly ventilated places such as closets or bookshelves.
Do not place the projector on cloth or papers, as these materials could be drawn into the air inlet port.
Do not set up the projector in humid or dusty places or in places where the projector may come into contact with oily smoke or steam.
Using the projector under such conditions may result in fire, electric shocks or plastic deterioration. The plastic deterioration may cause the falling down of the projector which is mounted in the ceiling.
Do not set up the projector in a high temperature environment, such as near a heater or in direct sunlight.
Failure to observe this may result in fire, malfunction or plastic deterioration.
When disconnecting the mains lead, hold the plug, not the lead.
If the mains lead itself is pulled, the lead will become damaged, and fire,
Always disconnect all cables before moving the projector.
Moving the projector with cables still attached can damage the cables, which could cause fire or electric shocks to occur.
Do not place any heavy objects on top of the projector.
Failure to observe this may cause the projector to become unbalanced and fall, which could result in damage or injury.
Do not
Failure to observe this may cause the batteries to overheat, leak, explode or catch fire, and burns or other injury may result.
When inserting the batteries, make sure the polarities (+ and
If the batteries are inserted incorrectly, they may explode or leak, and fire, injury or contamination of the battery compartment and surrounding area may result.
Use only the specified batteries.
If incorrect or different kind of batteries are used, they may explode or leak, and fire, injury or contamination of the battery compartment and surrounding area may result.
