Bosch Appliances VOT-320 manual Adjusting the lens only Wfov lenses, Final assembly

22 en Installation VOT-320

4.5 Adjusting the lens (only WFOV lenses)

Cameras with 9 mm, 13 mm, and 19 mm cover a wide field of view (WFOV). For these lenses you may need to adjust the camera focus. You connect a service monitor in order to set-up the camera and adjust the lens. Any monitors that support a standard NTSC signal are suitable.

1.Connect the monitor to the BNC socket on the back of the camera module using a video cable (75 Ohm, BNC plug).

2.Check the image on the monitor.

3.If the camera focus needs to be adjusted, loosen the four fixing screws of the camera module.

4.Lift the camera module and slide it backwards in order to reach the lens.

5.Attach the focussing tool to the lens and turn it to set the focus.

6.Remove the focussing tool.

7.Lift the camera module and slide it back to the original position.

8.Refasten the four screws.

9.Disconnect the monitor after set-up.

All other lenses are preset and do not need to be adjusted.

4.6	Final assembly
	1.	Close unused holes with suitable plugs.
	2.	Close the cover and secure the latches using the tamper resistant screws and the
		provided torx wrench.
	3.	Loosen the two sunshield screws (M4 × 10) on the top of the housing.
	4.	Slide the sunshield to the desired position. It has a range of 50 mm (2 in).
	5.	Tighten the screws to lock the sunshade into position.

4.7Setup using Bosch Video Client

The Bosch Video Client program can be found on the product CD supplied. This program allows you to implement and set up the camera in the network quickly and conveniently.

NOTICE!

Using Bosch Video Client to set all parameters in the VOT-320 is an alternative to configuration by means of a Web browser, as described in chapter 5 of this manual.

Installing the program

1.Insert the product disc into the optical drive of the PC;

– The installation program should start automatically.

2.If installation does not start automatically, locate the BVC_installer.exe file on the disk and double-click it.

3.Follow the instructions on the screen to complete the installation.

Configuring the camera

You can start Bosch Video Client immediately after installation.

1. Double-click the icon on the desktop to start the program. Alternatively, start the

application via the Start button and the Programs menu (path: Start/Programs/Bosch Video Client/Bosch Video Client).

2.When the program is started for the first time, a wizard opens to help you detect and configure devices on the network.

DOC V4.5 2010.09 Installation and Operating Manual Bosch Sicherheitssysteme GmbH