20 en Installation | VOT-320 |
| |
Pan/tilt connection
The pan/tilt connections are used to control a suitable Bosch pan/tilt.
Other pan/tilts may be controlled via the serial interface (see Section Data interface, page 19). The connections are located on the two 5-pin terminal blocks (see Section 8.8 Terminal blocks, page 99).
NOTICE!
The release letter for the current firmware version includes a list of compatible Bosch pan/ tilts.
CAUTION!
Please take note of the appropriate documentation when installing and operating the unit to be controlled.
The documentation contains important safety instructions and information about permitted uses.
Alarm inputs
The VOT-320 has two alarm inputs on the lower 6-pin terminal block (see Section 8.8 Terminal blocks, page 99). The alarm inputs are used to connect to external alarm devices such as door contacts or sensors. With the appropriate configuration, an alarm sensor can automatically connect the VOT-320 to a remote location, for example.
A zero potential closing contact or switch can be used as the actuator.
NOTICE!
If possible, use a bounce-free contact system as the actuator.
Connect the lines to the appropriate terminals on the lower 6-pin terminal block (IN1 and IN2) and check that the connection is secure.
Relay outputs
The VOT-320 has two relay outputs for switching external units such as lamps or alarm sirens. You can operate these relay outputs manually while there is an active connection to the VOT-320. The outputs can also be configured to automatically activate sirens or other alarm units in response to an alarm signal. The relay outputs are also located on the lower 6-pin terminal block (see Section 8.8 Terminal blocks, page 99).
CAUTION!
A maximum load of 30 Vp-p(SELV) and 200 mA may be applied to the relay contacts.
Connect the lines to the appropriate terminals on the lower 6-pin terminal block (R1 and R2) and check that the connection is secure.
