8 en Safety informationVOT-320
2 | Safety information |
2.1 | Electric shock hazard |
| – Never attempt to connect the camera to any power network other than the type for which |
| it is intended. |
| – Use only SELV power supply units with UL approval. |
| – Never open the cover of the camera module. |
| – Never open the housing of the power supply unit. |
| – If a fault occurs, disconnect the power supply unit from the power supply and from all |
| other units. |
| – Install the power supply only in a dry, |
| – If safe operation of the camera cannot be ensured, remove it from service and secure it to |
| prevent unauthorized operation. In such cases, have the unit checked by Bosch Security |
| Systems. |
| Safe operation is no longer possible in the following cases: |
| – if there is visible damage to the unit or power cables, |
| – if the unit no longer operates correctly, |
| – if internal components have been exposed to rain or moisture, |
| – if foreign bodies have penetrated the unit, |
| – after long storage under adverse conditions, or |
| – after exposure to extreme stress in transit. |
2.2 | Installation and operation |
| – The relevant electrical engineering regulations and guidelines must be complied with at |
all times during installation.
– Relevant knowledge of network technology is required to install the camera.
– Before installing or operating the camera, make sure you have read and understood the documentation for the other equipment connected to it, such as pan/tilts. The documentation contains important safety instructions and information about permitted uses.
– Perform only the installation and operation steps described in this manual. Any other actions may lead to personal injury, damage to property or damage to the equipment.
– Ensure a secure footing whenever working in elevated positions (e.g. on roofs or poles). Use only safety ladders. If necessary, use a safety harness or railings.
– Use only adequate cabes, e.g. marked “Outdoor Cable” or “Water Resistant” for outdoor installation. For the US, cables must comply with NATIONAL ELECTRICAL CODE, NFPA 70.
DOC V4.5 2010.09 | Installation and Operating Manual | Bosch Sicherheitssysteme GmbH |
