Bosch Appliances VOT-320 manual Remote port, Video output, Decoder, SSL encryption, Auto-connect

VOT-320 Configuration using a Web browser en 55

Remote port

Depending on the network configuration, select a browser port here. The ports for HTTPS connections will be available only if the On option is selected in the SSL encryption parameter.

Video output

If you know which unit is being used as the receiver, you can select the analog video output to which the signal should be switched. If the destination unit is unknown, it is advisable to select the First available option. In this case, the image is placed on the first free video output. This is an output on which there is no signal. The connected monitor only displays images when an alarm is triggered. If you select a particular video output and a split image is set for this output on the receiver, you can also select from Decoder the decoder in the receiver that is to be used to display the alarm image.

NOTICE!

Refer to the destination unit documentation concerning image display options and available video outputs.

Decoder

Select a decoder of the receiver to display the alarm image. The decoder selected has an impact on the position of the image in a split screen. For example, you can specify that the upper-right quadrant should be used to display the alarm image on a VIP XD by selecting Decoder 2.

SSL encryption

The data for the connection, for example the password, can be securely transmitted with SSL encryption. If you have selected the On option, only encrypted ports are offered in the Remote port parameter.

NOTICE!

Please note that the SSL encryption must be activated and configured at both ends of a connection. This requires the appropriate certificates to be uploaded onto the VOT-320 (see Section SSL certificate, page 79).

You can activate and configure encryption of the media data (video and metadata) on the Encryption page (see Section 5.38 Advanced Mode: Encryption, page 77).

Auto-connect

Select the On option to automatically re-establish a connection to one of the previously specified IP addresses after each reboot, after a connection breakdown or after a network failure.

NOTICE!

In the default setting, Stream 1 is transmitted for automatic connections. Bear this fact in mind when assigning the profile (see Section 5.17 Advanced Mode: Encoder Profile, page 40).

Bosch Sicherheitssysteme GmbH Installation and Operating Manual DOC V4.5 2010.09