46 en Configuration using a Web browser

VOT-320

 

 

Recording media

Select the required recording media here so that you can then activate them and configure the recording parameters.

iSCSI Media

If you want to use an iSCSI system as a recording medium, you must set up a connection to the required iSCSI system and set the configuration parameters.

NOTICE!

The iSCSI storage system selected must be available on the network and completely set up. Amongst other things, it must have an IP address and be divided into logical drives (LUN).

1.Enter the IP address of the required iSCSI target in the iSCSI IP address field.

2.If the iSCSI target is password protected, enter this into the Password field.

3.Click the Read button. The connection to the IP address will be established. In the Storage overview field, you can see the corresponding logical drives.

Local Media

The supported local recording media are displayed in the Storage overview field.

Activating and configuring storage media

The storage overview displays the available storage media. You can select individual media or iSCSI drives and transfer these to the Managed storage media list. You can activate the storage media in this list and configure them for storage.

CAUTION!

Each storage medium can only be associated with one user. If a storage medium is already being used by another user, you can decouple the user and connect the drive with the VOT-320. Before decoupling, make absolutely sure that the previous user no longer needs the storage medium.

1.In the Recording media section, click the iSCSI Media and Local Media tabs to display the applicable storage media in the overview.

2.In the Storage overview section, double-click the required storage medium, an iSCSI LUN or one of the other available drives. The medium is then added to the Managed storage media list. In the Status column, newly added media are indicated by the status Not active.

3.Click the Set button to activate all media in the Managed storage media list. In the Status column, these are indicated by the status Online.

4.Check the box in the Rec. 1 or Rec. 2 column to specify which data stream should be recorded on the storage media selected. Rec. 1 stores Stream 1, Rec. 2 stores Stream 2. This means that you can record the standard data stream on a hard drive and record alarm images on the local SD card, for example.

5.Check the boxes for the Overwrite older recordings option to specify which older recordings can be overwritten once all the available memory capacity has been used. Recording 1 corresponds to Stream 1, Recording 2 corresponds to Stream 2.

CAUTION!

If older recordings are not allowed to be overwritten when the available memory capacity has been used, the recording in question will be stopped. You can specify limitations for overwriting old recordings by configuring the retention time (see Section 5.21 Advanced Mode: Retention Time, page 50).

DOC V4.5 2010.09

Installation and Operating Manual

Bosch Sicherheitssysteme GmbH

Page 46
Image 46
Bosch Appliances VOT-320 manual Recording media, ISCSI Media, Local Media, Activating and configuring storage media