90 en Operation

VOT-320

 

 

Bookmarks

In addition, you can set markers in the sequences, so-called bookmarks, and leap directly to these. These bookmarks are indicated as small yellow arrows above the time interval. Use the bookmarks as follows:

Jump to the previous bookmark

Set bookmark

Jump to the following bookmark

 

NOTICE!

 

Bookmarks are only valid while you are in the RECORDINGS page; they are not saved with the

 

sequences. As soon as you leave the page all bookmarks are deleted.

 

 

6.7

Hardware connections between video servers

 

A VOT-320 can be used as a sender and a compatible hardware decoder (such as the VIP XD)

 

with a connected monitor as a receiver using an Ethernet network connection. In this way it is

 

possible to cover long distances without the need for major installation or cabling work.

 

 

 

NOTICE!

 

The sender and receiver must be located in the same subnet to establish a hardware

 

connection.

 

 

 

Installation

 

Compatible video servers are designed to connect to one another automatically, provided

 

they are correctly configured. They only need to be part of a closed network. Proceed as

 

follows to install the units:

 

1.

Connect the units to the closed network using Ethernet cables.

 

2.

Connect them to the power supply.

NOTICE!

Make sure that the units are configured for the network environment and that the correct IP address for the remote location to be contacted in the event of an alarm is set on the Alarm Connections configuration page (see Section 5.24 Advanced Mode: Alarm Connections,

page 53).

Connecting

There are three options for establishing a connection between a sender and a compatible receiver in a closed network:

an alarm,

a terminal program, or

Internet Explorer.

DOC V4.5 2010.09

Installation and Operating Manual

Bosch Sicherheitssysteme GmbH

Page 90
Image 90
Bosch Appliances VOT-320 manual Hardware connections between video servers, Bookmarks, Connecting