54 en Configuration using a Web browser

VOT-320

 

 

Connect on alarm

Select On so that the VOT-320 automatically connects to a predefined IP address in the event of an alarm.

By setting Follows input 1 the camera maintains the connection that has been automatically established for as long as an alarm exists on alarm input 1.

NOTICE!

In the default setting, Stream 1 is transmitted for alarm connections. Bear this fact in mind when assigning the profile (see Section 5.17 Advanced Mode: Encoder Profile, page 40).

Number of destination IP address

Specify the numbers of the IP addresses to be contacted in the event of an alarm. The camera contacts the remote stations one after the other in the numbered sequence until a connection is made.

Destination IP address

For each number, enter the corresponding IP address for the desired remote station.

Destination password

If the remote station is password protected, enter the password here.

In this page, you can save a maximum of ten destination IP addresses and hence up to ten passwords for connecting to remote stations. If connections to more than ten remote stations are to be possible, for example when initiating connections via higher-ranking systems such as Bosch Video Client or Bosch Video Management System, you can store a general password here. The VOT-320 can use this general password to connect to all remote stations protected with the same password. In this case, proceed as follows:

1.In the Number of destination IP address list field, select 10.

2.Enter the address 0.0.0.0 in the Destination IP address field.

3.Enter your chosen password in the Destination password field.

4.Define this password as the user password for all remote stations to which a connection is to be possible.

NOTICE!

If you enter the destination IP address 0.0.0.0 for destination 10, the VOT-320 will no longer use this address for the tenth attempt at automatic connection in the event of an alarm. The parameter is then used only to save the general password.

Video transmission

If the camera is operated behind a firewall, TCP (HTTP port) should be selected as the transfer protocol. For use in a local network, select UDP.

CAUTION!

Please note that in some circumstances, a larger bandwidth must be available on the network for additional video images in the event of an alarm, in case multicast operation is not possible. To enable multicast operation, select the UDP option for the Video transmission parameter here and on the Network page (see Section Video transmission, page 70).

Stream

Select the stream for transmission in case of an alarm.

DOC V4.5 2010.09

Installation and Operating Manual

Bosch Sicherheitssysteme GmbH

Page 54
Image 54
Bosch Appliances VOT-320 Connect on alarm, Number of destination IP address, Destination IP address, Destination password