Panasonic PT-LC56U Bright, Color, Tint, Sharpness, White Balance R/G/B, Tv-System, Still Mode

BRIGHT

This adjusts the darker areas (black areas) in the picture. Press the H button if dark areas are too solid (for example, if hair is difficult to see), and press the I button if black areas are too light (grey rather than black).

COLOR

(S-VIDEO/VIDEO/YPBPRonly) Press the H button to make the color more vivid in tone, and press the I button to make the color more pastel in tone.

TINT

(NTSC/NTSC 4.43/YPBPR only) This adjusts the flesh tones in the picture. Press the H button to make flesh tones more greenish, and press the I button to make the flesh tones more reddish.

SHARPNESS

Press the H button to make the picture details sharper, and press the I button to make the picture details softer.

Color Hue Setting (color temperature)

COLOR TEMP . STANDARD

[

HIGH

[�

LOW

This is used to adjust the white areas of the picture if they appear bluish or reddish.

WHITE BALANCE R/G/B

(RGB only)

This is used to adjust the white areas of the picture if they appear colorised. Press the I button to make the selected color lighter.

Press the H button to make the selected color stronger.

TV-SYSTEM

(S-VIDEO/VIDEO only)

TV - SYSTEM AUTO1

[

AUTO2

[

NTSC

[

NTSC4 . 43

[

PAL

[

PAL - M

[

PAL - N

[

SECAM

AUTO1

The projector automatically distinguishes between NTSC/NTSC 4.43/PAL/PAL60/SECAM signals.

AUTO2

The projector automatically distinguishes between NTSC/PAL- M/PAL-N signals.

NOTE:

BThis should normally be set to “AUTO1” or “AUTO2”. If the signal is of such poor quality that the correct format cannot be automatically distinguished, change the setting manually to the required TV system.

STILL MODE

STILL MODE	OFF
	[
	ON

To reduce flickering of still images (vertical flicker), set "STILL MODE" to “ON” by pressing the I or H buttons.

NOTE:

BDo not set “STILL MODE” to “ON” when playing back moving images.

SIGNAL MODE

(RGB/YPBPR only)

This displays the type of signal which is currently being projected.

Refer to the table on page 58 for details on each type of signal.

Projecting sRGB-compatible pictures

sRGB is an international color reproduction standard (IEC61966-2-1) established by the International Electrotechnical Commission (IEC). If you would like the colors in sRGB- compatible pictures to be reproduced more faithfully, make the following settings.

#Press the F or G button to select “PICTURE MODE”, and then use the I or H button to select “NATURAL”.

$Press the STANDARD (STD) button on the remote control unit.

%Press the F or G button to select “COLOR TEMP.”, and then use the I or H button to select “STANDARD”.

NOTE:

BsRGB is only enabled when RGB signals are being input (when LAMP POWER has been set to “HIGH”).

Adjustments and settings

36-ENGLISH ENGLISH-37