Installation
Television Location
This unit can be used as part of an entertainment center. Consult your dealer for available options.
•Avoid excessive sunlight or bright lights, including reflections.
•Keep away from excessive heat or moisture. Inadequate ventilation may cause internal component failure.
•Fluorescent lighting may reduce remote control transmitting range.
•Keep away from magnetic equipment, including motors, fans and external speakers.
Component Connection Cables
Shielded audio and video cables should be used between components. For best results:
•Use
•Use appropriate input and output connectors, that match your component connectors.
•Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION: TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE SLOT
OF AC OUTLET AND FULLY INSERT. DO NOT Polarized plug
USE A PLUG WITH A RECEPTACLE OR OTHER
OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
PROTECT POWER CORDS FROM BEING WALKED ON, ROLLED OVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS, CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXIT FROM THE APPARATUS.
Cable / Antenna Connection
For proper reception of analog or digital cable channels, a cable service connection is required.
INSTALLATION
Remote Control Battery Installation
Use two AA batteries (supplied):
1 | 2 |
| 3 |
|
|
|
| + |
|
| - |
| - |
|
|
| + |
| |
| + |
| - | |
| - |
| ||
|
|
| + | |
|
|
| + | |
|
|
|
|
1.Remove battery cover by pushing in on the catch while lifting the cover up.
2.Install batteries by matching (+) and
3.
Note: Incorrect installation can cause battery leakage and
corrosion that will damage the Remote Control.
Precautions
•Replace batteries in pairs.
•Do not mix battery types (example: zinc carbon with alkaline).
•Do not recharge, heat, short circuit, disassemble, or burn batteries.
•Battery replacement is necessary when the remote control acts sporadically or stops operating the selected device.
ENGLISH |
Cable Connection
Connect the cable supplied by your local cable company to ANTENNA (A) connection on back of television. Select Cable mode and ANTENNA (A) in SET UP menu under Program CH (Program Channels).
Incoming Cable from
Cable Company
75 Ohm ANT A
Antenna Connection
•For proper reception of digital and analog VHF/ UHF channels, an external antenna is required. For best reception an outdoor antenna is recommended.
• Connect home antenna to either ANT (A) or ANT (B) connection on back of the television. Select Antenna mode for ANTENNA (A) or
(B)in Input Setup under Program CH in Setup menu.
Note: Cable Mode is preset at the factory. Antenna users must change to ANTENNA Mode for ANTENNA (A) in the Set Up menu. If you have both Cable and Antenna, the Cable must be connected to ANT (A).
5z
