Click on “Properties” in “Internet Protocol (TCP/IP)”.

For reference: connecting this unit directly to a PC

When importing WMA/MP3 data (➜ page 40), creating a backup (➜ page 88), or restoring backed up data (➜ page 89), you can connect this unit directly to your PC with a cross LAN cable. When using this connection method, changes to the settings on this unit and your PC are necessary.

Preparation

1Connect this unit to the PC with a cross LAN cable (not included).

2To display the picture turn on the television and select the appropriate video input to suit the connections to this unit.

3Press [Í].

PC

Cross LAN cable

(not included)

To LAN terminal

To LAN terminal (10/100)

 

(100BASE-T or greater)

 

Settings on this unit

1 Press [SETUP].

2 Press [3 4] to select “Other Setup” and press

[ENTER].

Settings on the PC

For further information, refer to the operating instructions for your PC. These instructions are the examples of operating a PC with Windows XP operating system.

1 “Control Panel” > “Network Connections” > “Local Area Connections”, then click on “Properties”.

2

3 Select “Use the following IP address” and set the IP address and subnet mask.

[Note]

≥Connecting this unit to a PC in the manner described above may result in temporary loss of Internet connection. When using the Internet, change all the settings listed above back to the previous settings. You can also use the connection method described in “Network connection” (➜ page 20).

3

4

5

6

Press [3 4] to select “Network” and press [1].

Press [3 4] to select “Network Settings” and press [ENTER].

Press [3 4] to select “TCP/IP 1” and press [ENTER].

Press [3 4] to select “IP Manual Setting” and press [ENTER].

Set “IP Address”, “Subnet Mask”, and “Gateway”.

[Tips]

≥To make sure that you can reconnect to a network, we recommend taking note of the network setting values used (IP addresses, Gateway, etc.) before changing any network settings and/or values.

RQT8926

90