22
Basic features of 3D Eyewear
This product cannot be used as sunglasses.
This product can be worn over vision correction glasses.
Optional Accessory
TY-EW3D10U (as of April, 2010)
Visit http://www.panasonic.com/ for more information.
Part names and functions
Accessories
3D Eyewear (1)
3D Eyewear case (1)
Specialized band (1)
If the end of the specialized
band is loosened, make a loop
at the end as shown in the
above figure and smooth the
twisted rubber before using.
Nose pad (1 of each)
AB
Use either nose pad A or B
for your preference.
If you put the 3D Eyewear
on vision correction
glasses, the nose pad
is recommended to be
removed.
Viewing 3D images on TV
You can enjoy 3D images by wearing the 3D Eyewear supplied with this TV and to view 3D broadcasts and 3D image software.
Infra-red receiver
Receives infra-red signals from the television.
The liquid crystal shutter open/close timing is controlled by receiving infra-red
signals from the television, which provide 3D expression of the images.
Battery case
Fitting the batteries (p. 23)
When using for the first time,
remove the insulating sheet.
(p. 23)
Nose pad installation section
3D Eyewear inner section (p. 23)
Specialized band can be
attached here. (p. 23)
Liquid Crystal
Shutter
Controls the images for
3D viewing.
The left and right liquid
crystal shutters are
alternately opened
and closed in time with
the left side and right
side images that are
alternately displayed
on the television to
achieve the 3D effect.
Power button
(bottom side of 3D Eyewear)
Switches on the 3D Eyewear power.
Indicator lamp
Power button
Press and hold the power button for approximately
1 second to switch the power on, and the Indicator
lamp lights for approximately 2 seconds. To switch
the power off, press and hold the power button for
approximately 1 second. (The Indicator lamp flashes 3
times, then the power switches off.)
Specifications
Lens type Liquid Crystal Shutter type Dimensions Width: 6.97” (177 mm)
Height: 1.82” (46 mm)
Overall length: 6.86” (174 mm)
Batteries
(duration) Coin-shaped lithium battery CR2032
(approx. 75 hours in continuous use)
Usage temperature
range
32 °F – 104 °F
(0 °C – 40 °C)
Power supply DC 3 V
Mass (including batteries)
0.14 lb (63 g)
Viewing range* Transmitter for 3D Eyewear
Within 3.2m from front surface
(Within ±35° horizontal, ±20° vertical) Materials Main body: resin
Lens section: Liquid crystal glass
* Viewing range: The location of the 3D Eyewear transmitter (p.13)