Viewing 3D images on TV (Continued)
Viewing 3D images
Using the television menu controls, set so that 3D images are shown.
You can watch 3D images in the following cases: (As of February 2010)
•When a 3D image supporting
•3D image supported broadcast (program)
Press to exit from a menu screen
Press to return to the previous screen
Wearing the 3D Eyewear
Press and hold the power button on the 3D Eyewear for approximately 1 second. (The Indicator lamp lights for approximately 2 seconds.)
Put on the 3D Eyewear.
If the 3D Eyewear slips out of place, hold it in place using the specialized band, and adjust the length of the band. (p. 23)
If the 3D images are not displayed correctly or the images cause discomfort, the images can be adjusted by following this procedure.
*The perceived three dimensional effects of the 3D Eyewear differ from person to person.
Display the VIERA TOOLS screen and select “3D”
Using Setup menu (p. 39)
select
next
Select the item and set
3D settings (see below)
3D settings |
|
|
|
|
|
|
| select |
|
|
|
|
|
|
| ||
3D Eyewear |
| On |
|
|
|
| change | |
3D input format |
| Auto |
|
|
|
| ||
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Left / Right swap | Swapped |
|
|
|
|
| ||
Diagonal line filter |
| Off |
|
|
|
|
| |
Safety precautions |
|
|
|
|
|
|
|
|
After Use
Press and hold the power button on the 3D Eyewear for approximately 1 second. (The Indicator lamp on the 3D Eyewear flashes 3 times, then the power switches off.) After using the 3D Eyewear, store it in the case provided.
If the images cause discomfort, they can be adjusted with the following settings.
These settings are reset by switching inputs or selecting channel. (Settings will not be retained.)
3D Eyewear (On/Off) |
|
| Left / Right swap (Normal/Swapped) | ||||
| |||||||
|
|
|
|
|
|
|
|
3D Eyewear | On |
|
|
| Left / Right swap | Swapped |
|
3D settings
Off: 3D images can be deactivated by turning “Off” while viewing. (When 3D Eyewear is not worn)
3D input format
(Auto/Side by side/Top and bottom/Native)
3D input format | Auto |
Auto: (Default) When the HDMI receives information in which 3D mode is detected, 3D images are automatically displayed according to the signal. (Switching may not occur depending on the signal.)
Side by side/Top and bottom:
Allows you to set this setting to match the image state. Native: Displays the input signals as is on the screen. When the HDMI receives information in which Full HD (Frame Sequential Method) is detected, the image is automatically displayed regardless of “3D input format” settings.
Change this to On when the phases are reversed (when there is an unusual sense of depth).
Diagonal line filter (On/Off)
(Switch “Side by side” and “Top and bottom” types)
Diagonal line filter | Off |
|
|
|
|
On: Resolves discomfort caused by receiving a quincunx matrix signal.
Safety precautions
Displays message for viewing 3D images.
24 | * If a signal received from an external device is different from the 3D setting of the TV, such as 2D signal when the TV is set to |
3D mode, the images may not be displayed correctly. |
