Send documentation comments to mdsfeedback-doc@cisco.com.
Chapter2 Installing the Cisco MDS 9216 Switch
Pre-Installation
2-2
Cisco MDS 9216 Switch Hardware Installation Guide
78-16165-01
Warning
This unit is intended for installation in restricted access areas. A restricted
access area can be accessed only through the use of a special tool, lock and
key, or other means of security.
Statement 1017
Warning
Only trained and qualified personnel should be allowed to install, replace, or
service thisequipment.
Statement 1030
Warning
A readily accessible two-poled disconnect device must be incorporated in the
fixed wiring.
Statement 1022
Note “Rack” is used in this document to indicate either a rack or a cabinet.
Pre-Installation
This section provides the following information:
•Installation Guidelines, page2-2
•Required Equipment, page2-6
•Unpacking and Inspecting the Switch, page 2-6

Installation Guidelines

•Plan your site configuration and prepare the site before installing the chassis.
The recommended site planning tasks are listed in the Appendix D, “Site
Planning and Maintenance Records”.
•Ensure there is adequate space around the switch to allow for servicing the
switch and for adequate airflow (airflow requirements are listed in
Appendix B , “Technical Specifications”).