
Chapter 2 Installing the Cisco MDS 9216 Switch
Removing and Installing Components
Send documentation comments to mdsfeedback-doc@cisco.com.
This section provides the following information:
•Removing a Power Supply, page
•Installing a Power Supply, page
A
Warning Voltage is present on the backplane when the system is operating. To reduce risk of an electric shock, keep hands and fingers out of the power supply bays and backplane areas. Statement 166
Warning Power supply captive installation screws must be tight to ensure protective grounding continuity. Statement 289
Note You can replace the faulty power supply while the system is operating if the other power supply is functioning.
Removing a Power Supply
To remove a power supply, follow these steps:
Step 1 Turn the power switch to the off (0) position on the power supply you are removing.
Step 2 Loosen the screw on the power cable retainer and disconnect the power cable from the power supply being removed.
Step 3 Loosen the captive screw on the power supply.
Step 4 Grasp the power supply handle with one hand and slide the power supply out of the chassis.
Step 5 If the power supply bay is to remain empty, install a blank filler panel over the opening.
| Cisco MDS 9216 Switch Hardware Installation Guide |