Chapter 2 Installing the Cisco MDS 9216 Switch
Removing and Installing Components
Send documentation comments to mdsfeedback-doc@cisco.com.
Note If you purchased this product through a Cisco reseller, contact the reseller directly for technical support. If you purchased this product directly from Cisco, contact Cisco Technical Support at this URL: http://www.cisco.com/warp/public/687/Directory/DirTAC.shtml.
Step 11 Verify that the system software has booted and the switch has initialized without error messages. If any problems occur, refer to the Cisco MDS 9000 Family Troubleshooting Guide or the Cisco MDS 9000 Family System Messages Guide. If you cannot resolve an issue, contact your customer service representative.
Step 12 For future reference, complete the worksheets provided in Appendix D, “Site Planning and Maintenance Records”.
Note A setup utility automatically launches the first time you access the switch and guides you through the basic configuration. For instructions about how to configure the switch and check module connectivity, refer to the Cisco MDS 9000 Family Configuration Guide.
Removing and Installing Components
This section provides the following information:
•Removing and Installing Switching and Services Modules, page
•Removing and Installing Power Supplies, page
•Removing and Installing the Fan Module, page
Warning Hazardous voltage or energy is present on the backplane when the system is operating. Use caution when servicing. Statement 1034
Caution To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by the carrier edges only.
|
| Cisco MDS 9216 Switch Hardware Installation Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|
