Cisco Systems 9216 Removing and Installing Power Supplies

Send documentation comments to mdsfeedback-doc@cisco.com.

2-27

Cisco MDS 9216 Switch Hardware Installation Guide

78-16165-01

Chapter2 Installing the Cisco MDS 9216 Switch

Removing and Installing Components

d. While pressing down, simultaneously close the left and right ejector levers to

fully seat the module in the backplane connector. The ejector levers are fully

closed when they are flush with the module faceplate.

Note Ensure the ejector levers are fully closed before tightening the captive screws.

Failure to fully seat the module in the backplane connector can result in error

messages.

e. Tighten the two captive screws on the module.

To verify the module installation in slot 2, follow these steps:

Step1 Verify that the ejector levers of the module are fully closed (parallel to the

faceplate) to ensure that the module is fully seated in the backplane connectors.

Step2 Check the captive screws of the module, the power supply, and the fan module,

and tighten any loose captive screws.

Step3 If the slot is to remain empty, verify that a filler panel is installed and that the

screws holding the panel in place are tightened.

Step4 Turn on the power supply switches to power up the system and check the LEDs

on the module.

Note For information about how to check connectivity of the module, refer to the

Cisco MDS 9000 Family Configuration Guide.

Removing and Installing Power Supplies

The Cisco MDS 9216 Switch supports dual 845 WattAC power supplies that

monitor output voltage and provide status to the supervisor module.