Cisco Systems 9216 manual Removing and Installing Switching and Services Modules

Chapter 2 Installing the Cisco MDS 9216 Switch

Removing and Installing Components

Send documentation comments to mdsfeedback-doc@cisco.com.

Removing and Installing Switching and Services Modules

This section describes how to install a switching or services module in slot 2 of the Cisco MDS 9216 Switch. Slot 1 is reserved for the supervisor module with its integrated 16-port switching module. Slot 2 can contain an optional 16-port or 32-port switching module or a services module such as an 8-port IPS module. See Figure 1-1for slot locations.

This section provides the following information:

•Removing a Switching or Services Module from Slot 2, page 2-25

•Installing a Switching or Services Module in Slot 2, page 2-25

•Verifying Installation of a Switching or Services Module in Slot 2, page 2-27

Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or view directly with optical instruments. Statement 1051

Warning Use of controls, adjustments, or performing procedures other than those specified may result in hazardous radiation exposure. Statement 1057

Warning Hazardous voltage or energy is present on the backplane when the system is operating. Use caution when servicing. Statement 1034

Caution To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by the carrier edges only.

Note Install the Cisco MDS 9216 Switch in the rack before installing modules. For information about installing the chassis, see the “Installing the Chassis in the Rack” section on page 2-7.

	Cisco MDS 9216 Switch Hardware Installation Guide
2-22	78-16165-01