
Connection
PC Input Terminals Connection
| Less than |
| 10cm (4”) |
COMPUTER | |
| |
| Ferrite core |
| (Small size gray color) |
Conversion adapter (if necessary) | Stereo plug |
RGB
PC cable
Less than
10cm (4”) Ferrite core
(Small size white color)
Audio
Connect a cable which matches the audio output terminal on the computer.
Notes:
(1)Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
(2)The maximum resolution:
Model |
| Aspect | |
4:3 |
| 16:9 | |
|
| ||
| 768 ⋅ 768 |
| 1,024 ⋅ 768 |
| 1,024 ⋅ 768 |
| 1,366 ⋅ 768 |
If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.
(3)Some PC models cannot be connected to the set.
(4)There is no need to use an adapter for computers with IBM PC/AT compatible
(5)The computer shown in the illustration is for example purposes only.
(6)Additional equipment and cables shown are not supplied with this set.
Signal Names for D-sub 15P Connector
11 12 13 14 15
6 7 8 9 10
1 2 3 4 5
Pin Layout for PC Input Terminal
Pin No.
1
2
3
4
5
Signal Name
R
G
B
NC (not connected)
GND (Ground)
Pin No. | Signal Name | Pin No. | Signal Name |
6 | GND (Ground) | 11 | NC (not connected) |
7 | GND (Ground) | 12 | NC |
8 | GND (Ground) | 13 | HD/SYNC |
9 | NC (not connected) | 14 | VD |
10 | GND (Ground) | 15 | NC |
14