Panasonic TH-42PX500U manual Amplifier Connection to Audio AMP, Program Out Connection Prog OUT

Connection

Amplifier Connection (TO AUDIO AMP)

For a full Home Theater sound experience, an external Dolby Digital decoder and a multichannel amplifier must be connected to the DIGITAL AUDIO OUT terminal on the TV.

Dolby Digital 5.1 channel surround sound delivers digital-quality sound. Dolby Digital provides five discrete full- bandwidth channels for front left, front right, center, surround left and surround right, plus a LFE (Low Frequency Effect) subwoofer channel.

OPTICAL IN Optical digital audio cable

D I G I T A L

A U D I O O U T

or

G-	AUDIOIGITAL
	LINK	OUT

Back of the TV

D I G I TA L	C a b l e C A R D T M
AUDIO OUT	ANTENNA
G - L I N K	C a b l e I n
AUDIO INPUT
L	L

VIDEO

PC

	AV IN
	R	L
	AUDIO IN
Y	Y
PB	PB
	S VIDEO
PR	PR

VIDEO

R	R
	Audio cable

OUTPUT

Procedure

AUDIO OUT

1.Select Speakers “Off” in Audio menu (see page 27).

2.Adjust the amplifier volume to the desired level.

	L
AUDIO
AUDIO	R
IN

		L
		R
1	2	TO AUDIO AMP
COMPONENT VIDEO INPUT 1		INPUT 2 PROGOUT
	INPUT

Notes:

•Depending on your DVD player and DVD-Audio software the copyright protection function may operate and disable optical output.

•External speakers cannot be connected directly to OUTPUT terminals.

•When ATSC channel is selected, the output from the DIGITAL AUDIO OUT jack will be Dolby Digital. When NTSC channel is selected, the output will be PCM.

Program Out Connection (PROG OUT)

See optional equipment manual for further instructions for recording and monitoring.

		Back of the TV
				AV IN	R L
VCR	VIDEO
				Y	Y
					AUDIO IN
DVD recorder	INPUT
				PB	PB
		VIDEO			S VIDEO
	L
				PR	PR
	AUDIO
	INPUT	PC			L
	R
	AV cable	OUTPUT AUDIO	L
		AUDIO
		IN	R
					R
			1	2	TO AUDIO AMP
			COMPONENT VIDEO INPUT 1 INPUT 2 PROGOUT
				INPUT

VIDEO

Notes:

•The input signals connected to INPUT1 cannot be output from PROG. OUT terminals. (both picture and audio) However, output can be obtained from optical Digital Audio terminals.

(Input signals other than from INPUT1 can be output from PROG. OUT.)

•Connect the output of the Video recorder to INPUT1, when recording by using TV GUIDE.

•When a device (STB, DVD, etc.) is connected to the HDMI or COMPONENT terminals (see pages 12, 13), only audio signals will be output. No video signals will be output.

•When a schedule recording is activated on the TV Guide, the show will be recorded on a connected VCR. Please note that the screen will automatically be switched to the channel of the recorded show.

•When receiving digital channel signals, all digital formats are down-converted to composite NTSC video to be output through Program Out terminals.

•Some programs contain a Macrovision signal to prevent VCR recording.

11