Adjusting POS. /SIZE

Notes:

If the dot clock frequency is 162 MHz or higher, Dot Clock and Clock Phase cannot be made.

When digital RGB signal input, Dot Clock and Clock Phase cannot be made.

Auto Setup may not work when a cropped or dark image is input. In such case, switch to a bright image with borders and other objects are clearly shown, and then try auto setup again.

Depending on the signal, out of alignment may occur after Auto Setup. Carry out fine tuning for the position/size as required.

If Auto Setup cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz, 1280×768@60Hz, and 1366×768@60Hz), pre-selecting the individual signal in “XGA Mode” (see page 50) may results in correct Auto Setup.

Auto Setup does not work well when a signal such as additional information is superimposed out of valid image period or intervals between synchronizing and image signals are short, or for image signal with tri-level synchronizing signal added.

If Auto Setup cannot adjust correctly, select “Normalise” once and press ACTION (), then adjust Pos. /Size manually.

H-Pos

Adjust the horizontal position.

V-Pos

Adjust the vertical position.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

H-Size

Adjust the horizontal size.

V-Size

Adjust the vertical size.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Dot Clock

(During “Component”, “RGB” and “PC” input signal)

 

Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,

 

adjust so that any such noise is minimized.

Clock

(During “Component”, “RGB” and “PC” input signal)

Phase

Eliminate the flickering and distortion.

Over scan

Turn image over scan On/Off.

 

Configurable signals are as follows:

 

525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, RGB, DVI, SDI, HDMI)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

OnOff

Notes:

When “Off” is set, “H-Size” and “V-Size” cannot be adjusted.

When the “Display size” is set to “On” in the Options menu, this setting will be invalid. (see page 55)

24