Using Network Function
This unit has a network function to control the network connected display with your computer.
Note:
To use the network function, set each “Network Setup” setting and make sure to set the “Control I/F Select” to “LAN”. (see page 53)
When “LAN” is set, the slot power is turned on, and power indicator is lit orange under the condition of power “Off” with remote control
Example of Network Connection
COMPUTER
Display (main unit, rear)
Less than 10 cm
LAN cable |
|
| AUDIO PR/CR/R PB/CB/B Y/G |
(not supplied) |
|
| LAN COMPONENT/RGB IN |
Ferrite core | Ferrite core | Noise cut filter | SLOT3 |
| |||
(supplied) | (supplied) | (supplied) |
|
Installing the Ferrite core
Less
thanOpen 10 cm
|
|
|
|
|
|
|
|
|
|
|
|
| Pull back the tabs | Wind the cable twice | Press the cable through |
|
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
| (in two places) |
| and close |
Hub or broadband router |
| ||||||||||||||
|
|
| |||||||||||||
Notes:
•Lay the LAN cable away from other connection cables (excluding the power cord).
•Make sure the broadband router or hub supports
•To connect a device using
•Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge. Do not touch the LAN terminal or a metal part of the LAN cable.
•For instructions on how to connect, consult your network administrator.
Securing the LAN cable
When using a pedestal
Clamper
Note: In accordance with the Installation Instructions, secure the LAN cable so that it will not become near the display unit.
Command Control
Network function of the unit can control the unit in the same way as serial control from a network.
Supported commands
Commands used in the serial control are supported. (see page 10)
Note:
Consult your local Panasonic dealer for detail instructions on command usage.
59