Maintenance

Care and Replacement

Replacing the Lamp unit

JJAir filter

The air filter should be replaced when cleaning is ineffective and when replacing the lamp unit. A replacement air filter is provided with a replacement lamp unit (ET-LAB80). Contact an Authorized Service Center for the optional air filter (TXFMZ01VKG7).

JJLamp unit

The lamp unit, ET-LAB80 is consumable and you must replace it regularly. It is recommended that a qualified technician carry the lamp unit replacement and consult with an Authorized Service Center.

JJNote on lamp unit replacement

zzHandle the lamp unit with special care as it is a glass product. Dropping or giving it a shock may cause it to burst or to be damaged.

zzIf you wish to discard the used lamp, please contact your local authorities or dealer and ask for the correct method of disposal.

zzPrepare a Phillips-head screwdriver.

zzWhen replacing the lamp unit, be sure to hold it by the handle.

zzHold the lamp unit horizontally to prevent broken pieces from scattering. When the projector is mounted in the ceiling, do not work directly under the

projector or put your face close to the projector, and pull out the lamp horizontally.

Note

zzPrior to replacing the lamp unit, allow it to cool down to prevent the risk of burns, damage and other hazards.

Remarks

zzDo not attempt replacement with an unauthorized lamp unit.

JJLamp unit replacement time

When the lamp is consumed, the brightness may decrease over time. 3 000 hours of use is the replacing time as a rough guide, and that might be shortened by the usage conditions, characteristics of the lamp unit or environmental conditions. You can find the duration of usage time by checking LAMP RUNTIME in the PROJECTOR SETUP menu. Do not use a lamp unit over 3 000 hours. Failure to observe this may result in explosion of the lamp.

 

ON-SCREEN DISPLAY

LAMP indicator

 

REPLACE LAMP

 

 

 

 

2 800 hours

Displays “REPLACE LAMP” on the upper left of the screen

 

for 30 seconds. If any button is pressed within 30 seconds,

 

 

the message disappears.

Illuminates red, even in the

3 000 hours

Displays “REPLACE LAMP” on the upper left of the screen,

standby mode.

and it will stay until you respond. The power is turned off

 

 

automatically in 10 minutes.

 

 

 

 

Remarks

zzThe guide time, 3 000 hours, is a rough estimate based on certain conditions and is not a guaranteed time.

48 - ENGLISH

Page 48
Image 48
Panasonic TQBJ0302 manual Care and Replacement Replacing the Lamp unit, JJLamp unit, JJNote on lamp unit replacement