Panasonic TZ-DRD100 Setup Satellite Setup Dish position, Setup Satellite Setup Signal Meter

Dish position screen

pqbuttons to highlight Dish Position. Dish Position sub menu is

ROLLER GUIDE MENU OPERATIONS

Setup : Satellite Setup – Dish position

This screen allows you to position your Satellite antenna by having the Digital Satellite Receiver provide approximate values for elevation, azimuth and tilt (marked in degrees), after the you have entered your 5-digit zip code.

qSat Setup

Sat Ports

Dish Pos

Sig Meter

Zip code for position		92154
Elevation
	51 degrees
Azimuth	166 degrees
Tilt	101 degrees

Enter zip code, press ACTION

Press uto change the zip code.

Procedure

In Sat Setup menu, press displayed.

Press ubutton to enter your Zip code. Use the numeric keys on the Remote Control to input your zip code numbers. Press ubutton to move to the next position.

Press ACTION button to enter the new zip code. Elevation, Azimuth and Tilt are automatically

rdisplayed after you press the ACTION button.

This information should be used to properly align and position the satellite antenna. These values are approximations. Proper alignment should also be verified by using the signal strength meter.

Setup : Satellite Setup – Signal Meter

Since the Digital Satellite Receiver is capable of receiving satellite programming from multiple DIRECTV satellites, the user has the ability to choose one of 3 supported satellites to receive signal strength and is primarily used during the system set-up procedure. The Digital Satellite Receiver signal meter uses a horizontal digital signal strength percent bar meter. The user will have the ability to select which transponder (1 to 32) they wish to measure the signal strength. The following is the signal meter screen.

qSat Setup

Sat Ports

Dish Pos

Sig Meter

Satellite	A
Transponder	1 of 32
Signal strength 91%

Press uto change satellite.

Signal Meter Screen

Procedure

In the Sat. Setup menu, press qbutton to highlight Signal Meter. Sub- menu is displayed. Press to highlight Satellite.

Press uto change Satellite

Press pqbuttons to select Satellite A, B or C. Press ACTION to enter the selection.

Press	button to highlight Transponder.
Press	ubutton then pqbuttons to choose one of 32 transponders. Select the transponder

rthat gives you a signal strength of 85%. Press ttwo times to return to SETUP menu.

39