7
Basic
operations

1. Basic operations

1-1. Background transition

1-1-1. Selecting the bus

Press one of the crosspoint buttons to select the material to
be used for the background transition.
Depending on the operating status, the button pressed will
light in one of two colors.
Lighting in
red
When the selected input signals are output to
PGM.
(However, the indicator lights in amber during
FTB operations.)
Lighting in
green
When the selected input signals are not output
to PGM.
ヱヨヮ
モ
ヱヴヵ
ャ
モヶヹ
ヒバヒピ ビバヒフ ピバヒブ フバヒプ ブバヒヘ プバヒベ ヘバヒペ ベバビパ ペバビヒ ヒパバビビ ヒヒバビピ ヒビバビフ
ヴラリョヵ
ヴラリョヵ
ヴラリョヵ
Lighting in red
Lighting in green
When the crosspoint buttons are held down, the button
numbers and the names of the input materials assigned to
the buttons are displayed on the built-in display in the form
of a list for as long as the crosspoint buttons remain held
down.
CROSS POINT ASSIGN
XPT:
SIG:
12
SHIFT
11
A1
10
DVI
9
IN8
8
IN7
7
IN6
6
IN5
5
IN4
4
IN3
3
IN2
2
IN1
1
BLK
XPT:
SIG:
24
SHIFT
23
None
22
CLN
21
KOUT
20
None
19
None
18
ST1V
17
CBD1
16
CBAR
15
B2
14
B1
13
A2

1-1-2. Selecting the bus using the SHIFT

function

The SHIFT function enables two materials to be allocated —
the front material and the rear material — to one button, and
the materials to be selected using the [SHIFT] button.
A total of 24 materials — front materials (1 to 12) and rear
materials (13 to 24) — can be allocated to the three groups of
12 crosspoint buttons whether these buttons are the PGM/A
bus crosspoint buttons, PST/B bus crosspoint buttons or AUX
bus crosspoint buttons.
There are actually two SHIFT functions: “All SHIFT” for
switching all the front materials to the rear materials or vice
versa, and “Single SHIFT” for switching the front material of
one crosspoint button with its rear material or vice versa.
“All SHIFT” works once the SHIFT function has been
allocated to one of the user buttons.
“Single SHIFT” works once the SHIFT function has been
allocated to the No.12 or No.1 crosspoint button of the
crosspoint button group concerned by a menu operation.
All SHIFT
All SHIFT is used to switch all the materials of the PGM/A bus
crosspoint buttons, PST/B bus crosspoint buttons or AUX bus
crosspoint buttons from front materials to rear materials or
vice versa.
The user button to which the SHIFT function has been
allocated is used to switch between the front materials and
rear materials.
Allocate the SHIFT function to one of the user buttons.
(For the method used to allocate this function to the
user button, refer to “3-3-1. Setting the user buttons”.)
Each time the [SHIFT] button (user button) is pressed,
the front materials are switched to the rear materials or
vice versa.
When the rear materials (13 to 24) have been selected,
the [SHIFT] button (user button) lights in amber.
When the button is pressed again, it goes off, and the
front materials (1 to 12) are now selected.