Precautions for Installation
The following points as well as the contents of "Warning" and "Caution" shall be observed.
Installation work shall be performed in accordance with the technology standard of the electric installation.
The product is designed to be installed under eaves.
Keep the product out of direct sunlight.
Installing place
Contact your dealer for assistance if you are unsure of an appropriate place in your particu- lar environment.
•Make sure that the installation area is strong enough to hold the product, such as a concrete ceiling.
•Install the camera in the foundation area of the architecture or where sufficient strength is assured.
•If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently reinforced.
Avoid installing this product in the follow- ing locations.
•Locations where a chemical agent is used such as a swimming pool.
•Locations subject to steam and oil smoke such as a kitchen, Locations near flamma- ble gas or vapor.
•Locations where radiation or
•Locations where corrosive gas is pro- duced, Locations where it may be dam- aged by briny air such as seashores.
•Locations where the temperature is not within
•Locations subject to vibrations (This prod- uct is not designed for
Avoid moist or dusty places to install this system.
Otherwise, lifetime of the internal parts may be shortened.
Avoid installing the camera in a place with a high level of noise.
Installation near an air conditioner, an air clean- er, a vending machine, or the like causes noise.
Be sure to remove this product if it is not in use.
Keep the camera cable away from the lighting cable.
Failure to observe this may cause noise.
Radio interference
When the camera is used near TV/radio anten- na, strong electric field or magnetic field (near a motor or a transformer), images may be dis- torted and noise sound may be produced.
In such a case, run the camera cable through specialized steel conduit tubes.
Locally procure the screws
Screws are not supplied with this product. Pre- pare the screws according to the material, structure, strength and other factors of the mounting area and the total weight of objects to be mounted.
10
