Preparations
When installing the camera on a wall or a ceiling, there are two methods as specified below. (+ Next page)
•Using a
•Using the mounting base
Refer to all work related to the installation of this product to qualified service personnel or system installer.
•The mounting base
•The mounting base
Important:
•Prepare the mounting screw according to the material of the area where the camera attach- ment (accessory) is to be installed. In this case, wood screws and nails should not be used. For mounting a camera on a concrete ceiling, use an anchor bolt (M4) or an AY plug bolt (M4) for securing.
(Recommended tightening torque M4: 1.6 N·m {1.18 lbf·ft})
•When using the provided camera attachment, make sure that either of the arrow marks faces upward.
•Required
•If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently reinforced.
•When using an optional mounting bracket, refer to the operating instructions of the bracket in use.
The mounting conditions of the camera mount bracket are described as follows:
Installation | Applicable mount | Recommended | Number | Minimum |
place | bracket | screw | of screw | strength |
|
|
|
| (per 1 pc.) |
|
|
|
|
|
Ceiling/wall | M4 or equivalent | 4 pcs. | 196 N {44.06 lbf} | |
|
|
|
|
|
Ceiling/wall | M4 or equivalent | 4 pcs. | 196 N {44.06 lbf} | |
| (approx. 350 g {0.77 lbs}) |
|
|
|
Ceiling | – | – | * | |
| (approx. 700 g {1.55 lbs}) |
|
|
|
*Make sure that the installed mount bracket can support more than 5 times of the weight of the camera.
15