Important:
• Use all of 4 pairs (8 pins) of the LAN |
cable. |
• The maximum cable length is 100 m. |
• Make sure that the PoE device in use is |
compliant with IEEE802.3af standard. |
• When connecting both the AC 24 V/DC |
12 V power supply and the PoE device |
for power supply, PoE will be used for |
GND
ALARM OUT (Alarm out terminal)
ALARM IN
(Alarm in terminal)
AUX OUT
(AUX out terminal)
Cut
Approx.
9 mm - 10 mm
power supply. |
• When disconnecting the LAN cable |
once, connect the cable again after 2 |
seconds or more from the disconnection. |
When the cable is connected before 2 |
seconds passed, the power may not be |
supplied from the PoE device. |
• Refer to the provided slip (Recommend- |
ed network devices for PoE (IEEE802.3af |
compliant) connection with the WV- |
NP244) for applicable PoE devices. |
Step 4
Connect a LAN cable (category 5 or better) to the network connector on the rear of the camera.
MONITOR OUT LINK | LAN cable | ||
|
|
| |
INITIAL SET |
|
|
|
EXT I/O | SD |
|
|
1 2 3 4 | CARD |
|
|
POWER
GND
AC 24V IN : 1L – 2N
DC 12V IN : ! – @
Step 5
Connect an external device to the EXT I/O connector.
When connecting an external device, remove 9 mm – 10 mm of the outer jacket of the cable and twist the cable core to prevent the short circuit first.
Specification of cable (wire):
AWG #22 - #28
Single core, twisted
Important:
•Do not connect 2 wires or more directly to a terminal. When it is necessary to connect 2 wires or more, use a splitter.
<Ratings>
•ALARM IN OFF: Open
ON: Make contact with GND (0.5 mA or more)
•ALARM OUT
OPEN: Open Collector or DC 4 V – DC 5 V
Maximum applied voltage: 20 V
CLOSE: Make contact with GND (100 mA or less)
•AUX OUT
OPEN: Open Collector or DC 4 V – DC 5 V
Maximum applied voltage: 20 V
CLOSE: Make contact with GND (100 mA or less)
Important:
Connect an external device with verifying that the ratings are within the specifica- tions above.
15
